User Tools

Site Tools


en:arduino_modules

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
Last revision Both sides next revision
en:arduino_modules [2018/01/24 15:55]
ashley
en:arduino_modules [2018/01/24 16:48]
ashley
Line 2: Line 2:
 Any spacecraft contains in its composition the equipment that ensures the fulfillment of the flight mission. This equipment, for which the spacecraft is created or launched, is called the spacecraft payload. Any spacecraft contains in its composition the equipment that ensures the fulfillment of the flight mission. This equipment, for which the spacecraft is created or launched, is called the spacecraft payload.
  
-As part of the construction set, there are modules that are often used as a payload, for example, the camera. However, sometimes an extension of the set's functionality is required with the use of non-standard modules. The simple creation of such modules is provided by the open platform Arduino, which is integrated into the on-board information network of the construction set. The provided expansion module uses the Arduino Mega 2560 microcontroller board based on the ATmega2560 chip. The information exchange between the Arduino microcontroller and BCC occurs with the help of an expansion card (the so-called shield), which is installed on the motherboard ​with the microcontroller. The expansion card contains a connector for connecting RS-485 interface to the cable network through a standard loop.\\+As part of the construction set, there are modules that are often used as a payload, for example, the camera. However, sometimes an extension of the set's functionality is required with the use of non-standard modules. The simple creation of such modules is provided by the open platform Arduino, which is integrated into the on-board information network of the construction set. The provided expansion module uses the Arduino Mega 2560 microcontroller board based on the ATmega2560 chip. The information exchange between the Arduino microcontroller and BCC occurs with the help of an expansion card (the so-called shield), which is installed on the motherboard ​using the microcontroller. The expansion card contains a connector for connecting ​the RS-485 interface to the cable network through a standard loop.\\
  
 **Organization of information exchange**\\ ​ **Organization of information exchange**\\ ​
-The Arduino board has a serial UART port for communicating with other devices. For data exchange, digital I / O ports 0 (RX) and 1 (TX) and USB are used. RX and TX connectors, which connects the information network cable, are placed on the expansion card. It is necessary to connect the RX bus and board connectors and use the "​Serial"​ function set for Arduino to communicate between the microcontroller on the Arduino board and the BCC.\\+The Arduino board has a serial UART port for communicating with other devices. For data exchange, digital I / O ports 0 (RX) and 1 (TX) and USB port are used. The expansion card also houses the RX and TX connectors, ​to which connects the device'​s ​information network cable. It is necessary to connect the RX bus and board connectors and use the "​Serial"​ function set for Arduino to communicate between the microcontroller on the Arduino board and the BCC.\\
  
 **Principle of network operation**\\ **Principle of network operation**\\
en/arduino_modules.txt · Last modified: 2018/01/24 17:21 by ashley