User Tools

Site Tools


en:assembly

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Next revision Both sides next revision
en:assembly [2017/11/09 10:46]
rinin created
en:assembly [2018/01/16 18:22]
ashley
Line 2: Line 2:
  
 {{ ru:​htmlimage.jpg?​direct&​200|}} {{ ru:​htmlimage.jpg?​direct&​200|}}
-Structurally satellite model consists of a central cubic frame to which bodies ​of service modules and payload are mounted ​from inside or outside."The Satellite" is hung to the rail with elastic ​tough nylon thread length ​from a meter to a meter and a half. The satellite has one degree of freedom to imitate zero gravity ​during the rotation around ​the vertical axis.+Structurally, the satellite model consists of a central cubic frame to which the cases of the service modules and payload are mounted ​either on the inside or outside. The "​satellite" is suspended ​to the crossbar ​with tough elastic ​nylon thread ​about 1-1.5 meters in length. The satellite has one degree of freedom to imitate zero gravity ​while rotating about the vertical axis.
  
-**Note**: //the length of the thread is chosen ​from the condition ​of minimizing ​the impact to the cube'​s ​plane rotation. ​Bouncy ​rotational moment acting from the thread to the satelite ​still exists, but its impact is noticeable only when satellite twists several times.+**Note**: //the length of the thread is chosen ​based on which condition ​most minimizes ​the impact to the cube'​s ​planar ​rotation. ​An elastic ​rotational moment acting from the thread to the satellite ​still exists, but its impact is noticeable only when the satellite twists several times.
 // //
  
-The central cube consists of four side panels, bottom and cover panels. Side panels have ledges, bottom and cover panels have corresponding mortises to arrange the panels relative to each other. The final positioning is carried out with help of corner blocks.+The central cube consists of four side panels, ​bottom ​panel, ​and cover panel. Side panels have ledges, bottom and cover panels have corresponding mortises to arrange the panels relative to each other. The final positioning is carried out with help of corner blocks.
  
 On each panel there is a grid of screwed holes in 20 mm increments to attach modules to the central cube. The order of assembly, cabling and internal or external composition varies from the assigned task and is chosen by user. On each panel there is a grid of screwed holes in 20 mm increments to attach modules to the central cube. The order of assembly, cabling and internal or external composition varies from the assigned task and is chosen by user.
en/assembly.txt · Last modified: 2020/03/25 16:28 (external edit)