en:gc_interface
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
en:gc_interface [2019/12/30 14:50] golikov |
en:gc_interface [2020/01/20 12:37] golikov |
||
|---|---|---|---|
| Line 1: | Line 1: | ||
| - | **Mission Control Center** | + | ====== Mission Control Center ====== |
| **MCC Software** | **MCC Software** | ||
| Line 24: | Line 24: | ||
| * Run GroundControl.exe. | * Run GroundControl.exe. | ||
| - | Alternatively, the MCC software can be installed in any other folder. Important: the folder name must consist of Latin characters only without any special symbols (!#@ etc.) or spaces and should not begin with a digit. | + | <note important> |
| - | User Interface | + | **//Alternatively, the MCC software can be installed in any other folder. Important: the folder name must consist of Latin characters only without any special symbols (!#@ etc.) or spaces and should not begin with a digit.//** |
| + | </note> | ||
| + | |||
| + | **User Interface** | ||
| Here is the MCC window. | Here is the MCC window. | ||
| - | + | ||
| + | {{:en:mcc_window.png?800|}} | ||
| MCC has a single window with a set of fields: | MCC has a single window with a set of fields: | ||
| Line 38: | Line 43: | ||
| This field is used when working with the Terra Laboratory Setup. The satellite orbiting Earth is shown as a dot. Dark fields represent VHF/UHF station coverage areas while red dots show HF signal receiver stations. | This field is used when working with the Terra Laboratory Setup. The satellite orbiting Earth is shown as a dot. Dark fields represent VHF/UHF station coverage areas while red dots show HF signal receiver stations. | ||
| - | * Receiving telemetry | + | |
| - | * The field below displays information that comes from the satellite over the VHF/UHF radio channel (telemetry). | + | **Receiving telemetry** |
| - | * HF signal strength | + | |
| - | * This field displays the level of the light signal received by the HF receiver from the HF transceiver. When the program is started it may flash green to illustrate its operation and then will go off gradually. | + | The field below displays information that comes from the satellite over the VHF/UHF radio channel (telemetry). |
| - | * Camera views | + | |
| + | **HF signal strength ** | ||
| + | |||
| + | This field displays the level of the light signal received by the HF receiver from the HF transceiver. When the program is started it may flash green to illustrate its operation and then will go off gradually. | ||
| + | |||
| + | **Camera views ** | ||
| The SPUTNIX company logo in this field will be replaced by images received from the observation camera. For guidance on setting up the camera and receiving images, see the section titled Using the Earth Observation Camera. | The SPUTNIX company logo in this field will be replaced by images received from the observation camera. For guidance on setting up the camera and receiving images, see the section titled Using the Earth Observation Camera. | ||
en/gc_interface.txt · Last modified: 2020/03/25 16:28 (external edit)
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Noncommercial-Share Alike 4.0 International
