Differences

This shows you the differences between two versions of the page.

--- en:hf_rx_subsys [2018/01/23 17:41]
ashley
+++ en:hf_rx_subsys [2020/03/25 16:28]
@@ Line 1: / Line 1: @@
-**High-frequency receiver**
-{{ ru:hf_rx.jpg?direct&200|}}
-The high-frequency (HF), high-speed receiver is part of the construction set and simulates a ground station for receiving information over a high-speed channel. When carrying out the experiments, similar receivers will be mounted directly on the Earth's surface, i.e. on the [[sim_earth|globe]]. However, for the preliminary development of the "high speed radio channel," the construction set module should be used.
-This module works in conjunction with the Mission Control Center software (MCC). When you point it to the "beam" of the on-board [[hf_tx_subsys|HF transmitter]], the ground-based HF receiver signals to the MCC that the communication channel has successfully been established. The communication line must be retained in order to ensure accurate stabilization of the "satellite" - only in this case can the satellite payload data be transferred to the "Earth" through the communication channel.
-The quality of the communication channel, which depends on the targeting accuracy of the on-board HF transmitter on the MCC, is also taken into account. It determines whether the photo will be transmitted. A quality value between 0 and 100 is displayed in the upper right part of the MCC software interface.

Конструктор спутника "ОрбиКрафт"