What is Orbicraft for?
How to work with it
Orbicraft Subsystems
Arduino-Based payload
Lessons
Laboratory equipment
Feedback
News
What is Orbicraft for?
How to work with it
Orbicraft Subsystems
Arduino-Based payload
Lessons
Laboratory equipment
Feedback
News
This is an old revision of the document!
WiFi connection to the construction set network
WiFi connection is used by the developer to download and debug the on-board software from Earth and for high-speed transmission of information from payload during the exploitation of “The Satellite”. When electricity comes from power supply system to central on-board computer the loading of on-board software begins. After finishing the loading central computer creates its own WiFi network named SCHSAT. Name of network can be changed with help of web interface. It is highly recommended to change the name at the stage of preparing for final experiments “in the flight” with several “satellites” in case of several “satellites” can work on the one near-Earth orbit. This will help to avoid conflicts between networks in one room.
To work with MCC software for the time of experiment IP-address of PC WiFi adapter which will be used to work with the “Satellite” should be changed to 192.168.42.42. It can be done in network settings of the PC operating system. Only after that, you can connect to the network SCHSAT.